Delineating groundwater and subsurface structures by using 2D resistivity, gravity and 3D magnetic data interpretation around Cairo–Belbies Desert road, Egypt

Authors

Abstract

Geophysical tools such as magnetic, gravity and electric resistivity have been used to delineate subsurface structures, groundwater aquifer around Cairo–Belbies Desert road. A dipole–dipole section was measured at the central part of the study area with 2100 m length and electrode spacing 50 m for greater penetration depth. The results of the inverse resistivity data indicate that the study area includes two groundwater aquifers at different depths. The shallow aquifer water is near the surface and the deep aquifer lies at depth of about 115 m and exhibits low resistivity values ranging from 20 to 100 ohm m.
One hundred and fifty-two gravity stations were measured using Autograv gravimeter (CG3), different gravity corrections (drift, elevation and latitude corrections) were applied. The corrected data represented by Bouguer anomaly map were filtered into regional and residual gravity anomaly maps. The residual gravity map indicates that the area is dissected by many faults with NW-SE, N-S, E-W and NE-SW trends.
One hundred and fifty-three ground magnetic measurements are collected using two Proton magnetometers (Envimag). The corrected magnetic data are represented by total magnetic intensity map that was reduced to the magnetic pole. 3D magnetic modeling was applied to detect the depth of basaltic sheet and basement complex. The results indicated that the elevation of upper surface of basalt is ranging from 148 to −153 m and the elevation of lower surface of basalt is ranging from 148 to 269 m.

Keywords

NRIAG Journal of Astronomy and Geophysics
Volume 4, Issue 1
June 2015
Pages 134-146

Files

Share

How to cite

Statistics